Products :: Sluice Boxes & Stands


Buy Now

#00023 24"/30" Compact Sluice Stand

$68.00.....

This handy stand fits both our 24" and 30" compact Sluice Boxes. Constructed of 16 GA CRS. Zinc Platted (Gold Color). The Sluice Box is held on by two spring-locking clips. Stand folds down to 8" x 23". It comes with 4 independent (2-16" and 2-20") legs. Fits  7" x 2.5" Sluce ONLY!

 

 

 

Set Up
 
1. From new: Remove frame from box, noting this is in its
    original folded position.
2. Grasp frame in center with one hand. Holding the frame
    parallel to the ground, quickly release the bottom half of
    the frame so it swings downward and the spring clips are
    engaged into their locking holes. The frame should be
    locked rigid at this point. If not, apply light pressure to
    the spring clips to engage them into the locking holes.
3. Unscrew the stainless steel wing nuts from the four tube
    receivers.
4. Insert the two shorter 16” legs into the receivers at the
    exiting end next to the tabs and tighten wing nuts.
5. Insert the two longer 20” legs into the opposite end next
    to the snap clips and tighten wing nuts.
6. The holes at the base of the legs are intended to secure
     the frame to plywood for extended use.
7. Insert your 24” or 30” sluice box in the center of the frame.
8. Pick up the carpet slightly and slide sluice the under tabs.
    This holds the sluice box from sliding off the end.
9. Lift up the snap clip until they snap securely onto the top
    of the sluice box.
 
 

 

 
Operating Sluice Instructions
 
1. Refer to the Operating Instructions provided with your
    sluice box.
 
Storage
 
1. Unlatch the frame by grasping both clips with your
    thumbs at the same time and pull outward.
2. Ensure the frame is in its original folded position. If the
    snap clips collide together, your frame is in the wrong
    position. To put the frame in the correct position, rotate
    the frame 360° in the opposite direction until the tubes
    are parallel.
 
Helpful Hint
This folding frame was designed to enable us to ship the
frame more cost effectively, but is not necessary to re-fold
it.