Products :: Dry Washers

Buy Now

#00042 Royal King Drywasher


OUR ROYAL KING DRYWASHER IS THE LARGEST CAPACITY DRYWASHER MANUFACTURED IN THE USA! We pay special attention to building the best quility and the most durable machine with our customers in mind. This Drywasher has many fine features not found on any other Drywashers on the market today. Additional quality without the additonal price.

The Hopper is fully inclosed so no large rocks get in under the classifier clogging your adjustable flow valve.

Royal Kings Hopper is oversized at 40" x 27" for easy feeding.

Construced of 143 rivets making this a more durable stronger product.

All steel components are zinc plated for durability.

Full 56" high so that the hopper is at the proper work height.

49 lbs of Gold getting durability including stand.

Silicon rubber insolater on all chains connected to Recovery Box so that the static charge builds quicker, stronger and does not dissapate quickly.

Supplied with Easy, How To Use written instructions and a 70 min instructinal DVD.

This Drywasher is designed to use a 4" air hose (sold seperately, NOT INCLUDED).

100% made in America by Royal Manufacturing Ind.










Key Features:

The unit stands 56" Tall

.063" Aluminum

Hopper 40" x 27"

Recovery Box 34" x 14"

9 Zinc Platted Riffles (Gold Color)

All hardware made of Stainless Steel

49 lbs including Stand

Included with order, a 70 minute How To Video


Download Instructions

This machine supports 3 men shoveling.

Only use Dry Materials!

Before Operating 1. This Drywasher is designed to use a 4" air hose (not included)  2. Dry washers will only work with completely dry dirt. One can test this by grasping the soil and squeezing into a dirt ball. If any part of the soil stays in a ball, the dirt is not dry enough. You can lay a tarp out and place the dirt on the tarp and let it dry in the sun and / or remove layers of wet material until you reach dry material. Set Up 1. The solid frame is shipped in 1 piece versus the collapsible frame is shipped in 4 pieces.  Setting The Angles 1. Setting of the Hopper angle is done by pushing the buttons and moving the 3-position adjustment tube up and down, according to your materials. For dirt clods, use hole #1 (Top) flat position so they don’t roll off so you can work with them. The #2 hole (Center) is general purpose for rocks and gravels. The #3 hole (Bottom) is steep for self-cleaning for loose soils. 2. Setting of the Recovery Box angle is dictated when the machine and materials are both running, by moving the chain up and down to create the proper flow for specific materials. 3. The material should flow over riffles at a slow metered pace. Metering of the material is done by adjusting the flow valve located a bottom of Hopper. Loosen wing nuts and slide so it meters an even, steady flow. Once the desired flow rate is achieved, tighten wing nuts. 4. Too steep of Recovery Box angle would run too fast over riffles and not giving time for gold to settle. Too flat of an angle would cause material to back up and not flow. Adjust angle to your materials. Clean Out: 1. Place Gold Pan in combination with ¼” Mesh Classifying Screen directly under Recovery Box for best results. Remove chain and lower until it drops inside of Gold Pan. Release latch and raise riffles. Concentrates should slide right into Classified Pan. Pan out concentrates. Maintenance: From time to time you will need to slide out screen to remove ultra fine dust in Recovery Box. The bearings are inline skate bearings and should last years. Replacement bearings are available at any sports store that sells skate parts. Helpful Hints: It may be necessary to rev motor to higher RPM to get fan to start turning, or, pick up Recovery Box so it is in a flat positions until the fan starts turning. After fan starts turning, put Recovery Box back into its original position.